|
Pop off the plastic top of powdered medication and diluent
(liquid).
Swab the top of each vial with an alcohol pad to prevent contamination.
Remove the 1 ½ needle from the 3cc syringe and
attach the Q-Cap.
Holding the syringe, draw back 1cc of air into the syringe.
Place the spike end of the Q-Cap over the top of the sterile
diluent vial, and firmly push down until the Q-Cap spike is through
the rubber stopper. Press down on the plunger of the air filled
syringe to transfer the air into the vial in order to equalize
the pressure, which will make withdrawal of the diluent easier.
Invert, or turn upside down, the syringe with Q-Cap and vial
as one complete unit, and withdraw 1cc of the diluent. Remove
the Q-Cap and syringe from the vial by pulling on the syringe
barrel.
Hold the Menopur vial in one hand, grasp the sides of the
syringe in the other hand and place the tip of the Q-Cap over
the top of the vial and push the Q-Cap through the rubber stopper.
Slowly and cautiously deposit the diluent into the vial of powdered
medication. Rotate the vial between your thumb and index finger
until the solution is clear. Invert, or turn upside down the
syringe with Q-Cap and vial as one complete unit and withdraw
the contents of the vial.
Holding the syringe pointing upwards, twist the syringe counterclockwise
while holding the Q-Cap steady to remove the syringe from the
Q-Cap. Twist on the ½ needle for subcutaneous injection
or 1 ½ needle for intramuscular injection. Tap the
syringe to force any bubbles to the top. Depress the plunger
to expel the air.
If you are mixing a single vial, you are now
ready for your injection.
PROCEED
TO SUBCUTANEOUS INJECTION INSTRUCTIONS
If you are mixing a single vial, you are now
ready for your injection.
PROCEED
TO INTRAMUSCULAR INJECTION INSTRUCTIONS |